Download Raspbian at https:\/\/www.raspberrypi.org\/downloads\/raspbian\/<\/p>\n
RASPBIAN JESSIE WITH PIXEL or RASPBIAN JESSIE LITE and extract the file.<\/p>\n
$ unzip -x xxx-raspbian-jessie-xxx.zip<\/p>\n
In the computer insert the SD cards. If not, insert the card into an SD card reader, then connect the reader to your computer.<\/p>\n
Run df -h or lsblk. The new device that has appeared is your SD card.<\/p>\n
It will be listed as something like \/dev\/mmcblk0p1 or \/dev\/sdd1.
Run umount \/dev\/sdd1 or \/dev\/mmcblk0p1, replacing sdd1 or mmcblk0p1 with whatever your SD card's device name is (including the partition number).<\/p>\n
In the terminal, write the image to the card with the command below<\/p>\n
Make sure the device name is the name of the whole SD card as described above, not just a partition of it; for example, sdd, not sdds1 or sddp1, and mmcblk0, not mmcblk0p1.<\/p>\n
$ dd bs=4M if=2017-01-11-raspbian-jessie.img of=\/dev\/sdd<\/p>\n
Note: block size set to 4M will work most of the time; if not, please try 1M, although this will take considerably longer.<\/p>\n
Remove the SD card from the card reader.<\/p>\n
Insert the SD Card in the Raspberry and connect the power supply<\/p>\n
After the booting<\/p>\n
username: pi
password: raspberry<\/p>\n
Change the password from the pi user
$ passwd pi<\/p>\n
Configure the raspbian system
$ sudo raspi-config<\/p>\n
<\/p>\n
Credits <\/a><\/p>\n","protected":false},"excerpt":{"rendered":" Download Raspbian at https:\/\/www.raspberrypi.org\/downloads\/raspbian\/ RASPBIAN JESSIE WITH PIXEL or RASPBIAN JESSIE LITE and extract the file. $ unzip -x xxx-raspbian-jessie-xxx.zip In the computer insert the SD cards. If not, insert the card into an SD card reader, then connect the … Continue reading